Track Systems wrote:We are aware of the limitations for AutoX and are working hard to make Traqmate a first rate AutoX analysis tool. There is a sneak peek posted about this. I would welcome your feedback.
To answer your question, there are two methods I use to analyze autocross today.
1. Trim the sessions to the start point of the run and then overlay them.
2. Set a S/F right before the run and create a segment over the run area.
Perhaps other Traqmate users have some suggestions.
Todd wrote:Was the autox update ever made? It sure would be nice to align all the runs and trim them all in one shot Otherwise a quick analysis takes a half hour before you start analyzing. I sure am looking forward to the Traqview update. I hope all these things are addressed.
On another note, my last autox stopped recording early in the run, every run. I assume this is because I was in the same parking lot as an earlier event and it thought I reached the end. The weird part is looking at the Traqdash it appeared to still be recording? Any tips here? I try to create and name a new track each event, but that is a cumbersome job and more than half of the time I go through the process only to find the new track I created still does not exist.
Users browsing this forum: No registered users and 1 guest