You can set the Start / Finish location in one of four ways.
1. If a S/F is set in the Traqmate (complete only), it will transfer to the data.
2. If no S/F is set in the Traqmate, Traqview will pick a location on the track, generally near the pit exit.
3. You can drag and drop the S/F to a new location.
4. On the VCR control panel, position the reference vehicle (first driver listed on the Dashboard) and click Set Start/Finish.
After any of these methods, all segments, laptimes, and graphs are recalculated / redrawn.