Porsche 996 GT3 install

Post pictures of Traqmates in your race car, street car, bike, or boat.

Moderators: Track Systems, Andre' Surles

Rob in VA
Go Carts
Posts: 12
Joined: Wed Nov 05, 2008 12:02 pm

Porsche 996 GT3 install

Postby Rob in VA » Mon Dec 08, 2008 3:51 pm

My traqmate + traqdata install on my 2004 911 GT3.

1st off, a big thanks to Dell and Toby for their help and making this install possible.

I have three additional sensors hooked up via the traqdata module. They are RPM, brake pedal and TPS (throttle position sensor).

To get RPM I connected to the DME pin # E6.
To get the brake pedal I connected to the 3rd brake light. The positive lead is black/brown.
To get TPS I connected to the DME pin # D13.

Traqmate setup:
RPM, cylinders 1
Image

Brake, D4 (I was originally treating this as an analog signal)
Gas, A1 - Low 0.323v, High 1.633v, Alarm 2 volts (don't really care).

Important:
For whatever reason you will need to enter 0.339 for Low and 1.649 for High to get 0.323 Low and 1.633 High as the saved values. After entering the values verify the correct values were saved to the DU by clicking on "Save IO Setup", then close Traqview, reconnect and look at IO Data.
Image

Image

And now the pictures...

I piggy backed off my V1 hard install for power.
Image

Getting the wires routed to the back of the console.
Image

To make the unit fit, I had to cut out a void for the unit to slide back into to. The front of the console also had to be cut to fit the wires off the traqdata module and antenna and power cable.
Image

Notice the corner (bottom right), I cut an access slot to be able to screw the console down.
Image

The GPS antenna is routed along the bottom of the windshield and down the right pillar.
Image

Image

Image

I made a quick disconnect to the DME.
Image

This is where I tapped into the 3rd brake light.
Image

The project was fun, now I can't wait to get some real data. :D

Enjoy!

Note:
This installation may result in LIMP mode. See the thread below for more details. I'm still uncovering the problem/solution.

http://forums.rennlist.com/rennforums/9 ... -mode.html
Last edited by Rob in VA on Sun Dec 21, 2008 10:26 pm, edited 2 times in total.

Andre' Surles
Team Traqmate
Posts: 651
Joined: Mon Feb 07, 2005 5:53 pm
Contact:

Postby Andre' Surles » Mon Dec 15, 2008 10:17 am

Outstanding post, thanks Rob!
Andre' Surles
Track Systems
Redline! Redline! Redline!

Rob in VA
Go Carts
Posts: 12
Joined: Wed Nov 05, 2008 12:02 pm

Postby Rob in VA » Sun Dec 21, 2008 10:12 pm

More updates to the TPS settings.

Rob in VA
Go Carts
Posts: 12
Joined: Wed Nov 05, 2008 12:02 pm

Postby Rob in VA » Thu Jul 16, 2009 10:31 pm

Note:
This installation may result in LIMP mode. See the thread below for more details. I'm still uncovering the problem/solution.

http://forums.rennlist.com/rennforums/9 ... -mode.html

deputydog95
Pedal Cars
Posts: 7
Joined: Wed Jul 07, 2010 9:47 pm

Re: Porsche 996 GT3 install

Postby deputydog95 » Mon Aug 16, 2010 8:21 am

Did you encounter any problems?


Return to “Team Traqmate in Action”

Who is online

Users browsing this forum: No registered users and 0 guests

cron